Cisco 4948 installation manual

 · Catalyst Switch Software Features; Hardware System Features; Switch Components; Catalyst Switch Applications. The Catalyst switch (see Figure ) is designed for high-performance, high-density edge switching applications. It is a fixed configuration switching solution delivering 10// connectivity on all ports, supporting hot swappable, redundant power .  · The following is an overview of Catalyst features: • Layer 2, Layer 3, and Layer 4 switching services • Support for 32, MAC addresses for Layer 2 switching • Support for 2, VLANs and 4, VLAN IDs – IEEE Q VLAN tagging on all ports – Q-in-Q for EFM – Cisco Inter Switch Link (ISL) tagging on all ports. Catalyst GE Switch Installation Guide and provides information on how to obtain related documentation. Audience Only trained and qualified service personnel (as defined in IEC and AZ/NZS ) should install, replace, or service the equipment. Organization This guide is organized as follows: Chapter Title Description.

Figure Installing the Catalyst in the Rack. Step 4 Attach the cable guide to the right or left side of the chassis mount. Figure Installing the Cable Guide. Step 5 Do not connect the power cord at this time. Proceed to “Connecting AC Power to the Catalyst Switch” section. Loosen the two captive installation screws on the installed fan tray. Step 2 Grasp the fan assembly handle, and pull it outward; Page 76 Chapter 4 Removal and Replacement Procedures Removing and Installing the Fan Tray Catalyst E and Catalyst E-F Switch Installation Guide OL The following is an overview of Catalyst features: • Layer 2, Layer 3, and Layer 4 switching services • Support for 32, MAC addresses for Layer 2 switching • Support for 2, VLANs and 4, VLAN IDs – IEEE Q VLAN tagging on all ports – Q-in-Q for EFM – Cisco Inter Switch Link (ISL) tagging on all ports.

Chapter 4. X2 Port. Configuration. Describes how to install, remove, and maintain X2. Gigabit Ethernet modules. Page Preface. Related Documentation. Smart Install Configuration Guide. WS-C • WS-CGE. • WS-CX • WS-CX Step 5 vstack startup-vlan vlan_value. Using the architecture and setup, this revamped model now provides double the uplink capacity with 4 10GB Ethernet uplinks plus direct IPv6 hardware.